How to Lockout a Push Button Circuit Breaker: A Comprehensive Guide

.left-top {

top: 0;
left: 0;
float: left;
margin-right: 20px;
max-width: 380px;
}
.right-bottom {
float:right;
height:100%;
margin-left:15px;

}

and ABB SACE PR231/P Push Button Circuit Breaker.

When it comes to the ABB SACE PR231/P Push Button Circuit Breaker, it’s important to follow certain procedures to ensure the safety of everyone involved. This particular model has a push button mechanism that needs to be secured before any type of lockout can take place. Here’s how to properly lockout an ABB SACE PR231/P Push Button Circuit Breaker:

Step 1: Identify the power source
Before attempting to lockout the circuit breaker, it’s important to identify the power source of the equipment. Make sure to turn off any sources of electricity that could pose a risk to personnel or equipment.

Step 2: De-energize the circuit
Once the power source has been identified, it’s time to de-energize the circuit. This can be done by flipping the switch or shutting off the main breaker.

Step 3: Install the lockout device
Now that the power source has been turned off and circuit de-energized, it’s time to install the lockout device. The lockout device should be specifically designed for the ABB SACE PR231/P Push Button Circuit Breaker. Install the device as directed by the manufacturer.

Step 4: Secure the lockout
After the lockout device has been installed, it needs to be secured properly before any work can take place. This can be done using a padlock or other securing mechanism. The lockout should not be removable without a key or special tool.

Step 5: Test the circuit
Before starting any work on the equipment, it’s important to test the circuit to ensure that the lockout has been successful. This can be done using a voltage tester or other electrical testing device.

In conclusion, locking out an ABB SACE PR231/P Push Button Circuit Breaker requires careful attention to detail and adherence to safety procedures. By following the steps outlined above, you can help ensure the safety of personnel and equipment alike. Remember to always use the appropriate lockout devices for your specific equipment, and to test circuits before beginning any work.